Authors: Priya Prasad, Prasad Engineering, LLC; David C. Viano, Pro-Biomechanics, LLC; Chantal S. Parenteau, Roger Burnett , Design Research Engineering; Saeed D. Barbat, Ram Krishnaswami, Ford Motor Company
Abstract
Rear impacts have been among the safest modes of crashes, dating back to the beginning of the Safety Act in 1966. There are no dynamic tests in the FMVSS; however, two standards have addressed seat designs – FMVSS 207 set the minimum strength of seat backs in static tests and FMVSS202 set the geometry and stiffness of head restraint. The FMVSS 207 strength requirement has been controversial over the years, with some claiming that the standard’s seat back strength was too low. However, most seat backs were 2 to 3 times stronger than required by law in pre-1990 MY vehicles. The debate surrounding seat back strength continues, although seat backs in the post-2010 MY vehicles are nearly 10 times stronger than the requirements in the original regulation. Serious AIS3+ injury rates in rear end crashes (up to 40 km/h Delta-V) is less than 1%. Real world accident data indicates that low speed crashes (below 16 km/h Delta-V) have a preponderance of Soft Tissue Neck Injuries (STNI) or Whiplash Associated Disorders (WAD). In higher speed crashes, moderate-to-severe cervical spine and head injuries were reported. Between 1988 to 1995 Ford Motor Company launched a research project to identify dynamic test procedures to design future seats addressing low to high-speed rear end crashes without trading off the risk of injuries between low-speed and high-speed crashes. This entailed identifying Anthropomorphic Test Devices (ATDs), test procedures and acceptance criteria based on ATD responses. Detailed results of this effort are reported by Prasad et al. [1,2].
The purpose of this paper is to summarize the results of the research, describe the application of this research to a seat design that went into mass production with proven reduction in real world injuries, and the continuing use of these test procedures for design of seats in Model Years (MY) 2000 and beyond.

Type: Full Paper, Technical
© Stapp Association, 2026
Access Additional Papers from the 70th Stapp Car Crash Conference
View additional full papers from the 70th Stapp Car Crash Conference.
- A Dynamic Safety System for Mitigating the Severity of Motor Vehicle AccidentsAuthors: William G. Broadhead, Theodore Zinke, Automotive Safety Research, Inc.; Jacqueline G. Paver, Center for Injury Research Abstract The advent…
- Age-Associated Pediatric Head and Neck Injury Patterns in Motor Vehicle Crashes: A Multi-Source Descriptive AnalysisAuthors: Karthik Somasundaram, Klaus Driesslein, Dale Halloway, Medical College of Wisconsin; Valentina Graci, Children’s Hospital of Philadelphia/Drexel University Abstract Objective:…
- Biofidelity Evaluation of THOR-AV 50th Percentile Male Dummy in 50 km/h Frontal Impact ConditionsAuthors: Z. Jerry Wang, Humanetics Innovation Solutions; Matthew P. Reed, University of Michigan Transportation Research Institute Abstract This paper provides…
- Biomechanical Responses and Injuries of Male Post Mortem Human Subject Seated in Production Seats in Moderate-to-High-Speed Rear ImpactsAuthors: Yun-Seok Kang, Reed Finfrock, Timothy Wensink, Randee Hunter, Amanda M. Agnew, Injury Biomechanics Research Center, The Ohio State University;…
- Characterization of Rider and Powered Two-Wheeler Kinematics in Full-Scale PMHS Crash TestingAuthors: Daniel A. Meringolo, Yun-Seok Kang, Injury Biomechanics Research Center, The Ohio State University; Jolyon Carroll, Shiyang Meng, Autoliv Research…
- Evaluation of 50th Percentile Male ATD Biofidelity in Moderate-Speed Rear Impact Sled Tests Compared to PMHSAuthors: Angela Tesny, William Millis, Colton Thomas, Kevin Moorhouse, Jason Stammen, National Highway Traffic Safety Administration, Vehicle Research and Test…
- Factors and Mechanisms Related to Skeletal Ankle Injury during Frontal Motor Vehicle CollisionsAuthors: Devon L. Albert, University of Michigan Transportation Research Institute; Elizabeth M. McNeil, National Highway Traffic Safety Administration; Warren N….
- Historical Review of the Use of the Hybrid III ATDs in Rear Impact Testing and ValidationAuthors: Priya Prasad, Prasad Engineering, LLC; David C. Viano, Pro-Biomechanics, LLC; Chantal S. Parenteau, Roger Burnett , Design Research Engineering;…
- Identifying Representative Front Crash Test Conditions from EDR Pulses and Body-Region Injury PatternsAuthors: Matthew L. Brumbelow, Insurance Institute for Highway Safety Abstract As front crashworthiness has improved in relatively low-exposure, high-severity configurations,…
- Influence of Joint Structure in Multibody Model on Behavior Analysis of Crash Test DummyAuthors: Masatoshi Usui, Yasuhiro Matsui, Naruyuki Hosokawa, Yoshinori Tanaka, National Traffic Safety and Environment Laboratory, Tokyo, Japan Abstract This study…
- Parametric Investigation of the Effect of Brain Cortical Surface Representation on Strain Prediction: From a Smooth Cortex to Shallow Sulci in Multi-Block-Based All-Hexahedral Head ModelsAuthors: Sakib Ul Islam, Kewei Bian, Haojie Mao, Western University Abstract Developing finite element (FE) brain models with detailed sulci…
- Quantitative Assessment of Neck Injury Criteria Against Tissue-Level Response Using a Detailed Computational Neck Model in Frontal, Lateral, Rear, and Oblique ImpactsAuthors: Matheus A. Correia, Duane S. Cronin, University of Waterloo Abstract Neck injury criteria are increasingly used with computational Human…
- Relevant Vehicle Front-End Components for Pedestrian Laboratory Testing to Address Real-World Pedestrian Injuries When Struck by Passenger Vehicles With High Hood HeightsAuthors: Becky Mueller, Jessica Jermakian, Insurance Institute for Highway Safety Abstract In the United States, pedestrian deaths account for 18%…
- Response of the Male and Female PMHS Foot and Ankle to Axial LoadingAuthors: Warren N. Hardy, The Ohio State University; Elizabeth M. McNeil, National Highway Traffic Safety Administration; Devon L. Albert, University…
- Rotations of Rearward-Facing Child Restraint Systems and Excursions of the Paediatric Head During Frontal and Frontal-Oblique Impact Sled TestsAuthors: Declan A. Patton, Children’s Hospital of Philadelphia Abstract Objective: For a paediatric anthropomorphic test device (ATD) seated in rearward-facing…
- The Use of a Pre-Pretensioner Belt to Reduce Forward Leaning in Vehicle Occupants in Anticipation of a Pre-Crash ManeuverAuthors: Maitland Witmer, Valentina Graci, Children’s Hospital of Philadelphia/Drexel University; Madeline Griffith, Children’s Hospital of Philadelphia Abstract The objective of…
- Time-history Analysis of Model Validation and Corridor ComparisonAuthors: Guy Nusholtz Abstract To evaluate how data quality can influence the analysis of biomechanical impact tests, computationally generated sets…
- Video-based Accurate Kinematics Estimation from High-Speed Human MotionAuthors: Qiantailang Yuan, Svein Kleiven, Xiaogai Li, KTH Royal Institute of Technology Abstract Human posture and kinematics estimation from video…
- Voxel-Interpolation and Mapping Applied to Multiblock Hexahedral Finite Element Head Models Enables Response Metric Spatial ComparisonAuthors: Michael C. Bustamante, Duane S. Cronin, University of Waterloo Abstract Finite element (FE) head models (HMs) are used to…