Authors: Yun-Seok Kang, Reed Finfrock, Timothy Wensink, Randee Hunter, Amanda M. Agnew, Injury Biomechanics Research Center, The Ohio State University; Angela Tesny, William Millis, Kevin Moorhouse, National Highway Traffic Safety Administration, Vehicle Research and Test Center; Angelo Marcallini Jr., Transportation Research Center Inc.
Abstract
Moderate-to-high-speed rear-impact biomechanical data for mid-size male post-mortem human subjects (PMHS) seated in modern Original Equipment Manufacturer (OEM) seats remain limited. This study evaluated the kinematic and injury outcomes of mid-size male PMHS exposed to rear-impact sled conditions using four distinct OEM seats to establish biomechanical responses and document corresponding PMHS injuries. Six mid-size male PMHS were subjected to moderate-to-high-speed rear-impact tests on a HYGE sled. The experimental matrix evaluated two target average FMVSS301R pulses: 15g and delta-V of 36km/h (three PMHS tested with three different OEM seats) and 19g and delta-V of 29km/h (three PMHS tested using a single OEM seat). PMHS were seated in modern OEM vehicle seats equipped with head restraints and three-point seatbelt restraint systems. PMHS Instrumentation included chestbands on the thorax, strain gauges on the ribs, and accelerometers, and angular rate sensors installed at the head, cervical spine (C2, C4, and C6), thoracic spine (T1, T4, T8, and T12), and pelvis to capture PMHS kinematics. Pre- and post-test computed tomography (CT) scans and full anatomical dissections were conducted to identify PMHS injuries. All six PMHS exhibited consistent occupant loading sequences: pocketing into the seatback, initial thoracic spine straightening, ramping up the seatback, and head-to-head restraint interaction. Post-test dissection findings revealed cervical spine injuries in the C5–C7 region in two PMHS exposed to the higher acceleration pulse (19g, delta-V of 29km/h). PMHS also sustained rib fractures and thoracic vertebral fractures at T9 and T12. Head, cervical, and T1 kinematics were quantified to evaluate cervical spine injuries, while thoracic spine kinematics provided insight into thoracic spine and rib fracture mechanisms. The findings demonstrate that modern OEM seats tested at delta-V of 36km/h and 15g effectively mitigate severe head and neck hyperextension and thoracic spine injuries. However, increased sled acceleration input (15g to 19g) increased the prevalence of cervical and thoracic spine injuries. These results provide essential response corridors for mid-size male PMHS, serving as a critical baseline for validating advanced Anthropomorphic Test Devices (ATDs) and finite element human body models (HBMs) under moderate-to-high-speed rear impacts.

Type: Full Paper, Research
Keywords: PMHS, cervical injury, thoracic injury, rib fracture
© Stapp Association, 2026
Access Additional Papers from the 70th Stapp Car Crash Conference
View additional full papers from the 70th Stapp Car Crash Conference.
- A Dynamic Safety System for Mitigating the Severity of Motor Vehicle AccidentsAuthors: William G. Broadhead, Theodore Zinke, Automotive Safety Research, Inc.; Jacqueline G. Paver, Center for Injury Research Abstract The advent…
- Age-Associated Pediatric Head and Neck Injury Patterns in Motor Vehicle Crashes: A Multi-Source Descriptive AnalysisAuthors: Karthik Somasundaram, Klaus Driesslein, Dale Halloway, Medical College of Wisconsin; Valentina Graci, Children’s Hospital of Philadelphia/Drexel University Abstract Objective:…
- Biofidelity Evaluation of THOR-AV 50th Percentile Male Dummy in 50 km/h Frontal Impact ConditionsAuthors: Z. Jerry Wang, Humanetics Innovation Solutions; Matthew P. Reed, University of Michigan Transportation Research Institute Abstract This paper provides…
- Biomechanical Responses and Injuries of Male Post Mortem Human Subject Seated in Production Seats in Moderate-to-High-Speed Rear ImpactsAuthors: Yun-Seok Kang, Reed Finfrock, Timothy Wensink, Randee Hunter, Amanda M. Agnew, Injury Biomechanics Research Center, The Ohio State University;…
- Characterization of Rider and Powered Two-Wheeler Kinematics in Full-Scale PMHS Crash TestingAuthors: Daniel A. Meringolo, Yun-Seok Kang, Injury Biomechanics Research Center, The Ohio State University; Jolyon Carroll, Shiyang Meng, Autoliv Research…
- Evaluation of 50th Percentile Male ATD Biofidelity in Moderate-Speed Rear Impact Sled Tests Compared to PMHSAuthors: Angela Tesny, William Millis, Colton Thomas, Kevin Moorhouse, Jason Stammen, National Highway Traffic Safety Administration, Vehicle Research and Test…
- Factors and Mechanisms Related to Skeletal Ankle Injury during Frontal Motor Vehicle CollisionsAuthors: Devon L. Albert, University of Michigan Transportation Research Institute; Elizabeth M. McNeil, National Highway Traffic Safety Administration; Warren N….
- Historical Review of the Use of the Hybrid III ATDs in Rear Impact Testing and ValidationAuthors: Priya Prasad, Prasad Engineering, LLC; David C. Viano, Pro-Biomechanics, LLC; Chantal S. Parenteau, Roger Burnett , Design Research Engineering;…
- Identifying Representative Front Crash Test Conditions from EDR Pulses and Body-Region Injury PatternsAuthors: Matthew L. Brumbelow, Insurance Institute for Highway Safety Abstract As front crashworthiness has improved in relatively low-exposure, high-severity configurations,…
- Influence of Joint Structure in Multibody Model on Behavior Analysis of Crash Test DummyAuthors: Masatoshi Usui, Yasuhiro Matsui, Naruyuki Hosokawa, Yoshinori Tanaka, National Traffic Safety and Environment Laboratory, Tokyo, Japan Abstract This study…
- Parametric Investigation of the Effect of Brain Cortical Surface Representation on Strain Prediction: From a Smooth Cortex to Shallow Sulci in Multi-Block-Based All-Hexahedral Head ModelsAuthors: Sakib Ul Islam, Kewei Bian, Haojie Mao, Western University Abstract Developing finite element (FE) brain models with detailed sulci…
- Quantitative Assessment of Neck Injury Criteria Against Tissue-Level Response Using a Detailed Computational Neck Model in Frontal, Lateral, Rear, and Oblique ImpactsAuthors: Matheus A. Correia, Duane S. Cronin, University of Waterloo Abstract Neck injury criteria are increasingly used with computational Human…
- Relevant Vehicle Front-End Components for Pedestrian Laboratory Testing to Address Real-World Pedestrian Injuries When Struck by Passenger Vehicles With High Hood HeightsAuthors: Becky Mueller, Jessica Jermakian, Insurance Institute for Highway Safety Abstract In the United States, pedestrian deaths account for 18%…
- Response of the Male and Female PMHS Foot and Ankle to Axial LoadingAuthors: Warren N. Hardy, The Ohio State University; Elizabeth M. McNeil, National Highway Traffic Safety Administration; Devon L. Albert, University…
- Rotations of Rearward-Facing Child Restraint Systems and Excursions of the Paediatric Head During Frontal and Frontal-Oblique Impact Sled TestsAuthors: Declan A. Patton, Children’s Hospital of Philadelphia Abstract Objective: For a paediatric anthropomorphic test device (ATD) seated in rearward-facing…
- The Use of a Pre-Pretensioner Belt to Reduce Forward Leaning in Vehicle Occupants in Anticipation of a Pre-Crash ManeuverAuthors: Maitland Witmer, Valentina Graci, Children’s Hospital of Philadelphia/Drexel University; Madeline Griffith, Children’s Hospital of Philadelphia Abstract The objective of…
- Time-history Analysis of Model Validation and Corridor ComparisonAuthors: Guy Nusholtz Abstract To evaluate how data quality can influence the analysis of biomechanical impact tests, computationally generated sets…
- Video-based Accurate Kinematics Estimation from High-Speed Human MotionAuthors: Qiantailang Yuan, Svein Kleiven, Xiaogai Li, KTH Royal Institute of Technology Abstract Human posture and kinematics estimation from video…
- Voxel-Interpolation and Mapping Applied to Multiblock Hexahedral Finite Element Head Models Enables Response Metric Spatial ComparisonAuthors: Michael C. Bustamante, Duane S. Cronin, University of Waterloo Abstract Finite element (FE) head models (HMs) are used to…